Application

Mainly used for smelting cast iron,stainless stee,aloy steel, non-ferrous metals,including heavy metals (such as copper,lead) and

Steel shel

The open furace body includes: Whirwind dust removal environmental protection furnace lid and tilting furace oilcylinder, Furace id ifting, newinduction coil, energy saving yoke, full set of water inlet distributor, imported carbonless hose and so on.

Adopting hydraulic tilting device. The furace is welded with high quality steel structure, which is more sae,firm and durable; The sensor is enclosed by amagnetic yoke, cover area more than 65%. Therefore, less magnetic flux leakage, high efficiency,save nearly 5% energy consumption than aluminum shellfurace. Equipped with anti-leakage alarm device, can predict in advance to through the furmace, so as to achieve the purpose of safe production. Meanwhile.it can be equipped with the furnace lining ejector device.

The furnace lining ejector device consists of the following

1. Push out the oil cylinder.

2. Hydraulic valve and connecting pipe.

3.Furnace bottom joint matching the system

The system operates as follows

Once the furace lining cooling drops to 400'c, the fumace is tumed 90 degrees. Lift the oil cvlinder with a crane, conect the oil cylinder with the bottomof the furnace, start the hydraulic pump station and push out the furnace lining.

Products advantage

1. Good stability, low cost, smaller area occupied.

2. Easy to operate, fast melting and low production cost.

3.Simple structure, easy maintenance

4. Can be directly melted from the cold furnace, solution can be all empty, easy to replace the type of molten material

5. Low noise, good working environment.

6. Tailor-made according to the different melting metal.

7. induction coil f various specifications,reasonable selection of copper tube wallthickness and specificaions, so as to improve the utiization rate ofelectrical energy.

8. High performance insulation materials are used.

9. The turn-to-turn gap of the induction coil is convenient for maintenance and conductive to the release of water vaporSmoke collecting device can be used to improve working environment.

Power supplyThis melting furace can reaize fully automatic remote contro,including PLC programmable controler,HMl man-machine interface or industrial controlcomputer system,industrial control configuration software and various sensors.lt can realize automatic operation, such as automatic constant temperatureautomatic oven and furnace leakage alarm, which is safer and more convenient to use.

The power advantage

1. Through a single power supply device, realize the mass production capacity of multiple furnaces

2. Uninterruptible melting and accurate thermal insulation or overheat temperature control.

3. lt can preheat, sintering, melting and ultra-low power insulation for multiple electric furnaces at the same time.

4. Each furnace adopts independent control system.

5. Can provide full constant power to one furnace while isolating the other under maintenance.

6. Just one set of power connection and water connection, greatly reducing installation, operation and maintenance costs.

7. The latest generation of digital operation technology, Single Clip Microcomputer program control.

8.Lower starting frequency, ultra-low power oven.

9. Full open rectifier, high power factor, Higher harmonics are small.

10.The equipment power utilization rate is close to 100%

11. Liquid metal is more productive and does not need to increase electricity demand.

12. lt can produce efficiently and match different metal liquid demand levels.

13. Optical fiber transmission trigger signal, electronic control using digital mode.

14.Very competitive power consumption indicator.

15. Comply with domestic and international electrical safety design standards.

16. More perfect and intelligent protection function.